Wi-Fi 7-repeater 3600

Ingen gjenstander funnet.

Ingen gjenstander funnet.

Alle spørsmål

Wi-Fi 7-repeater 3600

I plug in the repeater and nothing happens. What should I check?

The Power LED is flashing. Is that normal?

Hva betyr LED-fargene?

The Wi-Fi LED is red. What should I do?

Where should I plug in the repeater for the best result?

How do I start the first-time setup?

I cannot find the default Wi-Fi network STRONG_Repeater in the list.

What is the Web UI password and how do I create it?

I have forgotten the Web UI password. What can I do?

What is the difference between Wireless Extender mode and Wireless Access Point mode?

How do I run the five-step setup wizard?

My router's network does not appear in the list at Step 3.

Should I use the same name as my router or a different one for the extended network?

How do I pair the repeater with my router using WPS?

Devices can connect to the extended network but have no Internet access.

The speed on the extended network is much lower than what I get from the router directly.

How do I reach the Web UI once the repeater is connected to my home network?

How do I rename the extended network or change its password?

I have a new router. How do I connect the repeater to it?

How do I switch from Wireless Extender to Wireless Access Point mode (or vice versa)?

How do I restore the repeater to its factory default settings?

What can I use the Ethernet port for?

Hvordan oppdaterer jeg fastvaren?

How do I save my configuration before making changes?

How do I schedule an automatic weekly reboot?

The LEDs disturb me at night. Can I turn them off?

What is the warranty period?

Where do I find the serial number and firmware version to contact support?

Ingen gjenstander funnet.

Ingen gjenstander funnet.

How do I restore the repeater to its factory default settings?

There are two methods:

Via the Web UI: Advanced Settings > System > Reset > click Reset. Confirm when prompted.
Via the physical pinhole: with the repeater powered on, insert a pin or paper clip into the Reset pinhole on the side panel and hold for about 10 seconds. The Power LED flashes to confirm the reset.

Warning: A factory reset permanently erases ALL settings: the Web UI password, Wi-Fi names, the host network connection, the timezone, and any scheduled reboot. After the reset you must run the setup wizard again. Never reset as a first troubleshooting step — try reconfiguring the host network first.

Følg oss