LEDs, buttons and ports

Create a new Wi-Fi Hotspot at a speed up to 300 Mbps in minutes by using your existing electrical wiring and any power socket!

Do you have trouble to cover some areas of your home with Wi-Fi? Do you need Wi-Fi in your loft, garret, basement or garden?
Simply connect the Powerline 600 adapter to your existing Internet modem through an Ethernet port and you will immediately have an Internet connection available at any power socket at a speed of up to 600 Mbps. Then by using a Powerline 600 Wi-Fi adapter you can create a new Wi-Fi Hotspot in the room of your choice and extend your Wi-Fi home coverage in minute at a speed up to 300 Mbps.

Do not waste your power outlets! Use the extra noise filtered power socket!

The Powerline 600 adapter is equipped with an extra noise filtered power socket. Why do you need it? Because you need to connect the Powerline 600 adapter to your modem/router in a place where very often other appliances need also a power supply. Do not waste any power outlet. Plug the Powerline 600 adapters directly into the wall outlet and use the extra noise filtered power socket to power your appliances or to plug in a power strip. The integrated noise filter reduces electrical interference and improves the performance of the Powerline communications.

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters please follow the steps below.

1Plug the adapters on a power strip

Connect the adapters one after the other to a power strip.

2Connect the adapters to the Internet

Connect each adapter to a working device (internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be a communication between the devices otherwise the adapter will automatically go into standby mode.

3Press the Connect & Secure button (first device)

Once the adapter is plugged in and connected to the Ethernet, simply press the “Connect & Secure” button on the front panel for 10 seconds.

4Press the Connect & Secure button (second device)

Press the “Connect & Secure” button on the front panel of the second device for 10 seconds. You have up to two minutes to do it.

5Home LED blinks

The home LEDs should start blinking.

6The adapter is reset

All the LEDs must be green at the end of the operations

Internet everywhere from any power socket!

The Powerline 600 Kit which includes two powerline 600 adapters, creates a high-speed home network effortlessly by using your home’s existing electrical wiring at speeds up to 600 Mbps. No new wire is required! Connect computers, consumer electronics and network compatible devices to the Internet in any room and any floor of your home by simply using a power outlet.

The home icon LED is lit on the Wi-Fi adapter, but I cannot connect to the Wi-Fi network of the Powerline 600.

1Connect to the Wi-Fi

To connect to the Wi-Fi Powerline for the first time, you must connect to the SSID indicated on the back of the product and use the Wi-Fi password also indicated.

Please note that the lower-case L can be confused with the upper case i, so please try the different possibilities

2Reset the Wi-Fi adapter

If you still cannot connect to the Powerline 600 Wi-Fi, please reset the Powerline Wi-Fi by pressing a paper clip in the hole located next to the Ethernet ports until the LEDs are flashing.

What do the icons and LEDs on the Powerline mean?

This image show the different statuses of the powerline 600 adapter.

This image show the different statuses of the powerline 600 Wi-Fi adapter.

Why do the Powerlines switch off on their own?

This is normal, Powerline 600 automatically switch to sleep mode if no activity is detected. When a signal is detected on the Ethernet port, the Powerline 600 will turn back on. It may take a few seconds for a Powerline 600 in standby mode to detect a new activity and turn back on.
The automatic power saving mode reduces your consumption by up to 85%.