LEDs, buttons and ports

Do not waste your power outlets! Use the extra noise filtered power socket!

Each Powerline 2000 adapter is equipped with an extra noise filtered power socket. Do not waste any power outlet. Plug the Powerline 2000 adapter directly into the wall socket and use the extra noise filtered power socket to power your appliances or to plug in a power strip. The integrated noise filter reduces electrical interference and improves the performance of the powerline communications.

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters, please follow the steps below.

1Put the adapters on a power strip

Connect the adapters one after the other to a power strip.

2Connect the adapters to the Internet

Connect each adapter to a working device (internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be a communication between the devices otherwise the adapter will automatically go into standby mode.

3Press the Connect & Secure button (first adapter)

Once the adapter is switched on and connected to Ethernet, simply press the “Secure & Connect” button on the right-hand side of the device for 15 seconds.

4Press the Connect & Secure button (second adapter)

Press the “Connect & Secure” button located on the right side of the second device for 15 seconds.

5Home LED blinks

The home icon LED should start blinking.

6Adapters are reset

All the LEDs must be green at the end of the operations.

Repeat the same operation for a third powerline. You can have up to eight Powerline 2000 on the same electrical installation.
After pairing all the devices, you can put them in the room where you need them.

I do not have access to the Internet and/or the LED of the "home" icon doesnot light up.

I do not have access to the Internet and/or the LED of the "home" icon does not light up.

You must reset the adapters to their factory settings. To reset the adapters
please follow the steps below.

1Put the adapters on a power strip

Connect the adapters one after the other to a power strip.

2Connect the adapters to the Internet

Connect each adapter to a working device (internet router/gateway, Android box, Smart TV, computer, etc.) with an Ethernet cable. There must be a communication between the devices otherwise the adapter will automatically go into standby mode.

3Press the Connect & Secure button (first adapter)

Once the adapter is plugged in and connected to the Ethernet, simply press the “Connect & Secure” button on the bottom for 10 seconds.

4Press the Connect & Secure button (second adapter)

Press the “Connect & Secure” button on the bottom of the second device for 10 seconds.

5Home LED blinks

The home icon LED should start blinking .

6Adapters are reset

All the LEDs must be green at the end of the operations.

Repeat the same operation for a third powerline. You can have up to eight Powerline 2000 on the same electrical installation.
After pairing all the devices, you can put them in the room where you need them.

Internet everywhere from any power socket!

The Powerline 2000 Kit which includes two Powerline 2000 adapters, creates a high-speed home network effortlessly by using your home’s existing electrical wiring at speeds up to 2000 Mbps. No new wire is required! Connect computers, consumer electronics and network compatible devices to the Internet in any room and any floor of your home by simply using a power outlet.

What do the icons and LEDs on the Powerline mean?

This illustration shows the different statuses of the pwoerline 2000 LEDs.

Why do the Powerlines switch off on their own?

This is normal, Powerline 2000 automatically switches to sleep mode if no activity is detected. When a signal is detected on the Ethernet port, the Powerline 2000 will turn back on. It may take a few seconds for a Powerline 2000 in standby mode to detect a new activity and turn back on.
The automatic power saving mode reduces your consumption by up to 85%.