Wi-Fi 7 REPEATER 3600

Nema pronađenih stavki.

Nema pronađenih stavki.

Sva pitanja

Wi-Fi 7 REPEATER 3600

I plug in the repeater and nothing happens. What should I check?

The Power LED is flashing. Is that normal?

Što znače boje LED dioda?

The Wi-Fi LED is red. What should I do?

Where should I plug in the repeater for the best result?

How do I start the first-time setup?

I cannot find the default Wi-Fi network STRONG_Repeater in the list.

What is the Web UI password and how do I create it?

I have forgotten the Web UI password. What can I do?

What is the difference between Wireless Extender mode and Wireless Access Point mode?

How do I run the five-step setup wizard?

My router's network does not appear in the list at Step 3.

Should I use the same name as my router or a different one for the extended network?

How do I pair the repeater with my router using WPS?

Devices can connect to the extended network but have no Internet access.

The speed on the extended network is much lower than what I get from the router directly.

How do I reach the Web UI once the repeater is connected to my home network?

How do I rename the extended network or change its password?

I have a new router. How do I connect the repeater to it?

How do I switch from Wireless Extender to Wireless Access Point mode (or vice versa)?

How do I restore the repeater to its factory default settings?

What can I use the Ethernet port for?

Kako ažuriram firmver?

How do I save my configuration before making changes?

How do I schedule an automatic weekly reboot?

The LEDs disturb me at night. Can I turn them off?

What is the warranty period?

Where do I find the serial number and firmware version to contact support?

Nema pronađenih stavki.

Nema pronađenih stavki.

Devices can connect to the extended network but have no Internet access.

Work through these checks in order:

Check the Wi-Fi LED on the repeater: if it is red, the repeater has lost its connection to the router. Move the repeater closer.
Verify that your router itself has Internet access by connecting a device directly to it.
Make sure you entered the correct password for the host network during Step 3 of the wizard. If you are not sure, relaunch Quick Setup and reselect the host network.
If you recently changed your router's Wi-Fi password, update it on the repeater: General Settings > Host Network in the Web UI.
In Access Point mode, check that the Ethernet cable is properly connected between the repeater's Gigabit Ethernet port and a LAN port of your modem or router.

Pratite nas