REPETIDOR Wi-Fi 7 3600

Nenhum item encontrado.

Nenhum item encontrado.

Todas as perguntas

REPETIDOR Wi-Fi 7 3600

I plug in the repeater and nothing happens. What should I check?

The Power LED is flashing. Is that normal?

O que significam as cores dos LEDs?

The Wi-Fi LED is red. What should I do?

Where should I plug in the repeater for the best result?

How do I start the first-time setup?

I cannot find the default Wi-Fi network STRONG_Repeater in the list.

What is the Web UI password and how do I create it?

I have forgotten the Web UI password. What can I do?

What is the difference between Wireless Extender mode and Wireless Access Point mode?

How do I run the five-step setup wizard?

My router's network does not appear in the list at Step 3.

Should I use the same name as my router or a different one for the extended network?

How do I pair the repeater with my router using WPS?

Devices can connect to the extended network but have no Internet access.

The speed on the extended network is much lower than what I get from the router directly.

How do I reach the Web UI once the repeater is connected to my home network?

How do I rename the extended network or change its password?

I have a new router. How do I connect the repeater to it?

How do I switch from Wireless Extender to Wireless Access Point mode (or vice versa)?

How do I restore the repeater to its factory default settings?

What can I use the Ethernet port for?

Como posso atualizar o firmware?

How do I save my configuration before making changes?

How do I schedule an automatic weekly reboot?

The LEDs disturb me at night. Can I turn them off?

What is the warranty period?

Where do I find the serial number and firmware version to contact support?

Nenhum item encontrado.

Nenhum item encontrado.

The LEDs disturb me at night. Can I turn them off?

Yes. Log in to the Web UI and go to Advanced Settings > System > LED Control. Disable the LEDs and click Apply. The repeater continues to operate normally — only the lights are off.

Tips: You can re-enable the LEDs at any time from the same page. If you need to check the status while LEDs are off, log in to the Web UI and go to System Status.

Siga-nos