Repeater AX1800
All questions
Reset, reboot and firmware update
How do I reboot my repeater?
1Connect to the Web UI
Connect to the Web UI by following this procedure.
2Reboot
Click Advanced Settings and Reboot.
3Pop up message
Click OK.
How do I reset my repeater to its factory settings? (Reset Button)
Press the reset button located on the left side of the repeater until the LEDs are off. The device will turn back on automatically once it is reset.
How do I reset my repeater to its factory settings? (Web UI)
1Connect to Wi-Fi or Internet Network of your repeater
You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration.
2Browse to the Web UI
Browse to the following URL: http://setup.strong
3Enter your credentials
Enter the password and click Connexion.
4Reset
Click Advanced Settings and Reset.
5Confirm the reset
Click OK.
How do I update the firmware of my repeater?
1Browse to the download section on https://www.strong-eu.com/
Before the update, you must go to the download section of our website to see if there is a new software version available.
2Download
To access the downloads, Click Assistance and Download in the top bar and its submenu.
3Select your product reference
Once, you have browsed to the Downloads page, click Home Networking and repeater and click the product reference.
4Firmware section
On the page below, you will find the new software version under the firmware section.
If you do not see a firmware section on the download page, it means that there is no new software version available.
5Connect to the Web UI
Follow this procedure to connect to the Web UI.
6Firmware
Click Advanced Settings and Firmware.
7Select the firmware file that you downloaded
Select your file and the update will start automatically.
Warning: Please wait for the update to be completed and for the device to restart. You
must reconnect to the Wi-Fi after the update.