Reset, reboot and firmware update

How do I reboot my repeater?

1Connect to the Repeater

You need to connect to the repeater by RJ45 or to connect to one of the Wi-Fi networks that was created after the configuration.

2Access the Web UI

Enter the URL of the Web UI in your browser.

3Log In to the Web Interface

Enter your administration credentials.

4Open the Setup Menu

Click Setup.

5Go to Device Reboot

Click DeviceReboot.

6Reboot the Repeater

Click Reboot Now.

How do I reset my repeater to its factory settings? (Reset Button)

Press the reset button located on the left side of the repeater until the LEDs are off. The device will turn back on automatically once it is reset.

Warning: After resetting the device, you will have to connect with the information written on the product label located under the repeater.

How do I reset my repeater to its factory settings? (Web UI)

1Connect to the Repeater

You must connect to the repeater by RJ45 or one of the Wi-Fi networks created after the configuration.

2Open the Web Interface

Enter the URL to access the Web UI in your browser

3Log In

Enter your administration credentials.

4Go to Setup

Click Setup.

5Open Backup/Restore

Click Backup/Restore

6Reset the Repeater

Click Reset.

How do I update the firmware of my repeater?

1Check for a Firmware Update

Before the update you must go in the download section of our website to see if there is a new software version available.

2Navigate to the Downloads Page

Click on ASSISTANCE > Downloads.

3Select Your Product

Once, you have browsed to the Downloads page, click Home Networking and repeater and click the product reference.

4Download the Firmware

On the page below, you will find the new software version under the firmware section. If a file is available, please download it.

5Connect to the Repeater

Once this is done, connect to the Wi-Fi of the repeater.

6Access the Web UI

Browse to the URL of the Web UI.

7Open the Setup Menu

Click Setup.

8Start the Firmware Upgrade

Click Upgrade Firmware.

9Apply the Update

Select your file and click Apply. Then, the update will start automatically.

Warning: Please wait for the update to be completed and for the device to restart. You must reconnect to the Wi-Fi after the update.